Electrical connectionFitting under a counter
This appliance must be earthed.(kitchen worktop or sink)
The manufacturer declines any responsibility should this
By removing the machines worktop, you can install it under a
safety measure not be observed.
close fitting sink unit or a pre-existing top, providing the
If the plug that is fitted to your appliance is not suitable for thedimensions of the recess correspond to those shown in the
socket, it must be cut off and the appropriate plug fitted.picture.
Important
Proceed as follows:
The wires on the mains lead are coloured in accordance with570 - 600
-Remove the machines
the following code:
worktop by unscrewing the
Green and Yellow - Earth
two rear retaining screws,
Blue- Neutralpull from the front and slide820
Brown- Liveout the rear slots, lifting the
worktop.600
If you fit your own plug, the colours of the wires in the mains
lead of your appliance may not correspond with the markings
identifying the terminals in your plug.IN05
Proceed as follows:
1.Connect the Green and Yellow (earth) wire to the terminal Insert the machine after adjusting height and levelling with the
in the plug which is marked with the letter "E" or the earth adjustable feet. When inserting the machine, ensure that the
water inlet and drain hoses are not kinked or squashed.
symbol or coloured green and yellow.
2.Connect the Blue (neutral) wire to the terminal in the plug
which is marked with the letter "N" or coloured black.
3.Connect the Brown (live) wire to the terminal in the plug
which is marked with the letter "L" or coloured red.
Levelling
Good levelling is essential for correct closure and sealing of
the door.
When the appliance is correctly levelled, the door will not catch
E
on the levelling spacers on either side of the cabinet.
13A
L
N
CE04
IN06IN07
The plug moulded onto the lead incorporates a 13amp BSI362
fuse. Only ASTA or BSI fuses should be used.If the door does not close correctly, loosen or tighten the
adjustable feet until the machine is perfectly level.
The plug must not be used if the fuse cover/carrier is lost. The
cover/carrier is indicated by the coloured insert at the base of
the plug.
A replacement cover/carrier must be obtained from your local
Service Force Centre.
17 |
ACEC
